2019-2020 Ducati Supersport S Maintenance Schedule

The 2019-2020 Ducati Supersport S maintenance schedule and service intervals — sourced from the owner’s manual.
This applies to these methods:
- 2019 Ducati Supersport S
- 2020 Ducati Supersport S
The service internal are very similar of those 2019-2020 Ducati Supersport.
Regular maintenance for the 2019-2020 Ducati Supersport S
This is maintenance that you can do yourself (though the manual says you need a dealer to do it).
Important
Using the motorcycle under extreme conditions, such as very damp and muddy roads or dusty and dry environment, could cause above-average wear of components like the drive system, the brakes or the air filter. If the air filter is dirty, the engine could get damaged. Therefore, this might translate in required service or replacement of the wear parts earlier than specified in the scheduled maintenance chart.
Every 1000 km/600 miles miles OR 6 months (whichever comes earlier, perform the following maintenance:
Check the engine oil level |
Check brake fluid level |
Check tyre pressure and wear |
Check the drive chain tension and lubrication |
Check the brake pads. If necessary, contact your dealer to replace pads |
2019-2020 Ducati Supersport S Maintenance Schedule Table
The following is the list of maintenance operations and to be done on this motorcycle with a distance or time interval — whichever comes earlier.
This maintenance schedule is in the same format as in the manual, though altered to fit this screen.
Attention
This scheduled maintenance chart is designed for a road use. If it is used on the track, even if not during sport competitions, all parts of the motorcycle are more stressed so the routine maintenance operations must be carried out more frequently than indicated.
Please contact a Ducati Dealer or authorised Service Centre where you can receive customised service advice according to the sport use you make.
The distances and times are mentioned below. Whenever the first of either the time or distance interval is reached, the maintenance is required.
Km. x1000 | 1 | 15 | 30 | 45 | 60 | Time |
mi. x1,000 | 0.6 | 9 | 18 | 27 | 36 | (months) |
Reading of the error memory with DDS 2.0 and check of
software version update on control units | • | • | • | • | • | 12 |
Check the presence of any technical updates and recall
campaigns | • | • | • | • | • | 12 |
Change engine oil and filter | • | • | • | • | • | 12 |
Clean the engine oil mesh filter assembly | • | • | • | – | ||
Check and/or adjust valve clearance | • | • | – | |||
Change timing belts | • | • | 60 | |||
Change spark plugs | • | • | • | • | – | |
Clean air filter | • | • | – | |||
Change air filter | • | • | – | |||
Check brake fluid level | • | • | • | • | • | 12 |
Change brake fluid | 36 | |||||
Check brake disc and pad wear. Change, if necessary | • | • | • | • | • | 12 |
Check the proper tightening of brake calliper bolts and
brake disc flange screws | • | • | • | • | • | 12 |
Check front and rear wheel nuts tightening | • | • | • | • | • | 12 |
Check frame-to-engine fasteners tightening | • | • | • | • | – | |
Check wheel hub bearings | • | • | – | |||
Check and lubricate the rear wheel shaft | • | • | – | |||
Check the cush drive damper on rear sprocket | • | • | – | |||
Check the proper tightening of final drive front and rear
sprocket nuts | • | • | • | • | • | 12 |
Check final drive (chain, front and rear sprocket) and sliding
shoe wear | • | • | • | • | 12 | |
Check final drive chain tension and lubrication | • | • | • | • | • | 12 |
Check steering bearings and lubricate, if necessary | • | • | – | |||
Change front fork fluid | • | – | ||||
Visually check the front fork and rear shock absorber seals | • | • | • | • | • | 12 |
Check the freedom of movement and tightening of the
side and central stand (if any) | • | • | • | • | • | 12 |
Visually check the fuel lines | • | • | • | • | 12 | |
Check rubbing points, clearance, freedom of movement
and positioning of hoses and electric wiring in view | • | • | • | • | • | 12 |
Check the free play of clutch lever | • | • | • | • | • | 12 |
Lubricate the levers at the handlebar and pedal controls | • | • | • | • | 12 | |
Change coolant | • | 48 | ||||
Check the coolant level and check circuit for damage | • | • | • | • | • | 12 |
Check tyre pressure and wear | • | • | • | • | • | 12 |
Check the battery charge level | • | • | • | • | • | 12 |
Check the operation of all electric safety devices (side
stand sensor, front and rear brake switches, engine kill switch, gear/neutral sensor) | • | • | • | • | • | 12 |
Check lighting, turn indicators, horn and controls | • | • | • | • | • | 12 |
Reset the Service indication through the DDS 2.0 | • | • | • | • | • | 12 |
Final test and road test of the motorcycle, testing safety
devices (ex. ABS and DTC), electric fans and idling | • | • | • | • | • | 12 |
Softly clean the motorcycle | • | • | • | • | • | 12 |
Fill out that the service was performed in on-board documentation
(Service Booklet) | • | • | • | • | • | 12 |
General Information on the 2019-2020 Ducati Supersport S
The SuperSport’s compact instrument panel has lights on the upper part of the dashboard for warnings relating to neutral, indicators, full beams, engine rpm limit, oil pressure and fuel reserve, while the lower part is comprised of an LCD display with a DOT-Matrix area to display all the other data.
The Plexiglas screen can be adjusted with just one hand; riders can raise it 50 mm and so obtain better airflow protection. Extreme attentiveness to the ergonomic triangle, aerodynamic protection and the rider’s freedom of movement has resulted in comfort, versatility and jaw-dropping sports handling.
2019-2020 Ducati Supersport S Owner’s Manual

The above info was sourced from the owner’s manual. You can download it below. You can download it from the Ducati website here.